JConcepts Posts a Fully Loaded Upgrade Guide for the B7.1
JConcepts has posted a Fully Loaded upgrade guide for the Team Associated RC10B7.1 and 7.1D 1/10 2WD electric buggies, covering chassis, steering, drivetrain and titanium hop-ups.
JConcepts has posted a Fully Loaded upgrade guide for the Team Associated RC10B7.1 and 7.1D, the 1/10 2WD electric buggies. It walks through their hop-ups from the chassis and bulkheads to steering, drivetrain and titanium hardware. They also say most of these parts fit the T7 and SC7.
A few of the key upgrades from the guide:
- Weight and chassis: a 7075 aluminum 0-degree front bulkhead at 9.3g, plus 25g steel bulkheads in 0-degree and 2.5-degree so you can add front weight and change kick-up in one part. There's a two-piece steel servo weight plate (9.5g, or 17.5g with the 8g insert), an aluminum electronics plate at 12.3g, and a steel electronics plate that can go up to 35.3g with its insert. They also have an aluminum battery hold set and pre-cut chassis protective sheets, including an RM2 "No Apologies" version.
- Suspension and steering: aluminum or steel D mounts, aluminum rear ball-stud and hub link mounts, caster hat bushings for carpet (0 and 3mm) and dirt (1 and 2mm), and an adjustable titanium front axle with spacers to change track width. The steering kit moves height adjustment to the rack ball-stud and adds a new servo-link pick-up point, with aluminum bellcranks and rack in the kit.
- Drivetrain and hardware: an aluminum motor plate, Silent Speed 48P spur gears (JConcepts says they're more concentric than standard molded gears), a 24-piece Radial NMB bearing set, Fin titanium turnbuckles, and titanium screw sets for the upper and lower sides of the build. There's also a one-piece aluminum rear wing button — that's wing hardware, not a wing.
The full rundown, with part numbers, is in the guide.



